There are three types of sensor technology used in smoke alarms: photoelectric, ionization and a combination or dual sensor that incorporates both sensors in one smoke alarm.
- Photoelectric: The sensor of choice. The photoelectric sensor responds faster to smoldering type fires that cause the most injuries and deaths in residences. It is also less prone to nuisance false alarms from cooking and steam.
- Ionization: The ionization sensor responds faster to flaming type fires. It is prone to nuisance false alarms from cooking and steam.
- Combination or Dual Sensor: Contains a photoelectric and ionization sensor. It is still prone to false alarms from cooking and steam due to the ionization component.
- Smoke alarms should bear the label of an approved testing agency (UL or FM).
- To aid in choosing the correct smoke alarm, look for the letter “P” or the word “photoelectric” on the packaging or description of the smoke alarm.
- Battery: Uses a 9 volt or AA batteries
- Long Life Battery: Power may last up to 10 years with a long-life lithium battery.
- Hardwired: Wired to the home 110 volt electrical service (with battery back-up)
Battery smoke alarms are readily available and can be installed by a homeowner or tenant. Hardwired alarms must be installed by a qualified electrician but can be easily replaced by the homeowner at the end of their service life or if faulty.
- Photoelectric smoke alarms should be placed, at a minimum, on every level of the home including the basement, outside every sleeping area and in every bedroom. Smoke alarms should be mounted on the ceiling or high on the wall (smoke rises). Always follow the manufacturer’s instructions.
- Additional smoke alarms can be added to increase your protection.
Testing and Maintenance
- Test each smoke alarm monthly by pushing the button.
- Replace 9 volt and AA batteries in smoke alarms twice a year. (Remember: change your clocks, change your batteries.)
- If the alarm “chirps,” warning that the battery is low, replace the battery right away.
- All smoke alarms have a recommended service life of 10 years. Replace your smoke alarms at this time or sooner if they are not functioning properly.
- Vacuum or dust out cobwebs that have accumulated in smoke alarms at least once per year.
- Consider installing interconnected photoelectric smoke alarms (wired or wireless). When one detector sounds, every detector throughout the house sounds.
- In the event of a false alarm, never remove the battery or disconnect the power source. Simply fan the smoke or steam away from the smoke alarm until the alarm stops.
- If a contractor or supplier is installing your smoke alarm, make sure you are provided with the manufacturer’s instructions.
- Many communities provide free smoke alarms and batteries to residents who cannot afford them, and may install them for you if you require assistance. Check with your local fire department.
- Smoke alarms are one component of a complete home fire escape plan. Have a plan and practice it.
For additional information please read the NEOFPA Position Paper, the General Public Recommendation on Smoke Detectors and the other material provided in the Smoke Detector Links located on this page.
Download Residential Smoke Alarm Guide here:
Residential Smoke Alarm Guide